User Manual
12
|
Turning On the Flash and Firing a Test
Turning On the Flash and Firing a Test Shot
To turn the ash on, press and hold the power button until the LCD illuminates. To turn the ash off, hold the
power button for approximately two seconds.
Flash ready indicator: The ash ready indicator lets you know when the ash is ready to re again. The
indicator will blink red when charging and remain lit when the ash is ready to re.
To re a test ash, press the Test button.
Depending on your camera model, a ash icon may also appear in the viewnder when the VC-310 is mounted
on your camera.
Sleep mode: After approximately two minutes of inactivity, the ash will automatically enter sleep mode
to conserve the battery life by turning off the LCD and ash ready light. To reactivate the VC-310, press the
Set button on the ash unit or press your camera’s shutter-release button halfway. During long periods of
inactivity, use the power switch to turn the ash off completely.
LCD illumination: When you turn the ash on the LCD illuminates for approximately ten seconds before
turning off to save battery life. Press any button on the ash to light up the display when you need to view the
LCD in a low light environment.