User Manual

Using the VC-310C as a Master in the Wireless Multi (Stroboscopic) Mode

1. Press the F2 function button [Hz] to highlight the stroboscopic frequency.

2. Press the left or right arrows to change the frequency.

3. Press the F2 function button [Hz] again to conrm frequency and highlight the Stroboscopic

count number.

4. Press the left or right arrows to set the Stroboscopic count number.

5. Press the Set button to conrm your settings.

Access the slave groups and slave group settings:

1. Press the F1 function button to cycle through group settings A, AB, and ABC. The default view in this mode

displays the power output level of group A.

2. Press the Set button to cycle through the power output levels for each group, followed by the channel

setting. Use the left and right arrows to adjust.

3. After setting the channel, press the Set button to conrm. There should be nothing highlighted on

the display.