User Manual
28
| Using Your VC-310C as a Wireless TTL Slave
Using Your VC-310C as a Wireless TTL Slave
To set the VC-310C ash unit as a wireless TTL slave, follow these steps:
1. Make sure the ash is on and set to E-TTL mode.
2. Press and hold the Mode button until the standard ash control [
] indicator is highlighted.
3. Press the right arrow repeatedly until the TTL slave mode [ ] indicator appears on the LCD.
4. Press the Set button to conrm.
5. Press the F1 function button repeatedly to cycle through the three groups until you set the desired group
for your slave ash unit.
6. Press the F2 function button repeatedly to cycle through the four channels available between the master
and groups.
7. Press the Set button to conrm your settings.
ETTL
GROUP A
GROUP
CH
CH1
Overview
1. Group
2. Channel
3. TTL slave indicator
1
2
3