User Manual
22
|
Multi (Stroboscopic) Mode
3. Press the Set button to conrm.
4. Press the F1 function button to change the Time. This will set the number ashes that re per exposure.
Use the right and left arrows to adjust the amount.
5. Press the F1 function button to conrm.
6. Press the F2 function button [Hz] to change the frequency, or the number of ashes per second. Use the
right and left arrows to adjust.
7. To conrm your settings, press the F2 function button repeatedly until nothing is highlighted on the LCD.
8. Press the shutter button to re a test shot. You should see several bursts of light.
Tip: To calculate the appropriate shutter speed, divide the number of ashes per frame by the frequency of
the ash.
For example, if the number of ashes per frame is 10, and the frequency of
the ash is 5 Hz, then the shutter speed should be 2 seconds or slower.
Note: See the Stroboscopic Reference chart on page 38 for the maximum number of ashes at various power/
frequency combinations.
10 ashes per frame
5 Hz
=2