VB-11 User Manual

Setting the Flash Power

The VB-Series ashes incorporate manually-controlled power output that can be varied over 8 stops from 1/1

(full power) to 1/128, and is adjustable in 1/3-stop increments. Turn the Selection Dial clockwise to raise the

power level, and counterclockwise lower it.

To avoid overheating and damaging your ash unit, please wait for at least 10 minutes after 75 continuous

ashes at full power. The ash will automatically enter thermal protection mode if it gets overheated. The LCD

screen will display and ash ring will be disabled until the unit has cooled.

NOTE: Turning the ash power output lower than 1/128 until “OF” is displayed will disable ash ring. This

feature is for use with a dedicated remote, such as the Impact ControlSync 16. For more information, see the

Dedicated Remote Control

section in

Triggering the Flash

, on the next page.

VB-11