User Manual

Connecting Your Cyclone
|
9
Battery LED 1 on: 25% or lower charge level
Battery LEDs 1-2 on: 25%-50% charge level
Battery LEDs 1-3 on: 50%-75% charge level
Battery LEDs 1-4 on: 75% or higher charge level
Connecting Your Cyclone to Your Flash
You can use the Cyclone to power a wide range of ash units. To connect the Cyclone to your ash unit, you
must use a compatible connection cable. Cables sold by some ash and battery pack manufacturers are
interchangeable with Bolt cables, but other ash brands use a different connector type. Make sure you select
the right one.
Important! Load your ash unit with its standard batteries before connecting it to the Cyclone.
Most compatible ash units require the standard batteries to be installed in order to power the computer
functions that allow the ash to work.
You may need to set your ash unit to recycle by drawing power from the Cyclone only to avoid draining the
installed batteries. Check your ash unit’s manual for details on the relevant setting.
STATUS
CHARGE
25%
50%
75%
FULL