Manual

7
Decoder Diagrams
1. Power Switch
To power on / off the decoder
2. 3.5mm IR IN
3. Power LED Indicator
Turns green when the decoder is connected to power and switched on
4. Codec LED Indicator
Green – Normal
Not lit - Abnormal/Error
5. System LED Indicator
Solid green - All ok, sync achieved
Amber – Booting up, waiting sync
Red - System failed to boot correctly
Off – No power
6. Error LED Indicator
Solid green - Software running
Blinking green - Identifying function activated
Solid or blinking red - Software fault or exception
Off - No power
7. Sync LED Indicator
Solid green - Dante network clock follower sync to leader achieved
Blinking green - Dante network clock leader
Amber - Syncing in progress
Red – sync error
Off - No power
8. HDCP LED Indicator
Solid green - Non HDCP unprotected video sink or source detected
Blinking green - HDCP protected content detected
Solid red - Invalid non-HDCP video sink or source
Blinking red - Failed HDCP negotiation
Blinking Amber - HDCP negotiation in progress
Off - No power
9. RS-422 Control Port
Connect to the keyboard controller RS422 port and use the standard Visca RS422 to control the
connected camera through the decoder
10. 3.5mm IR in for External IR Receiver Connection