Manual

NOTE: The USB interface on the decoder can only be used for keyboard and mouse connections. USB flash

drives / hard drives are not supported.

The diagram below illustrates the example setup described above.

Infrared Interface

Infrared control over IP allows an IR controller to remotely control a device via the Dante network. The decoder

equipped with 3.5mm jacks for infrared control over IP, right side is TX and left side is RX.

This function needs to work together with the Dante AV encoder.

How to setup

• Connect the IR transmitter to the IR TX port located on the encoder’s front panel

• Connect the IR receiver to the IR RX port located on the decoder front panel

• Using the Dante Controller, subscribe IR channel on the encoder to IR channel on the decoder. (In this

instance, the IR signal is being passed from the decoder across the network to the encoder.) //Should

verify the TX and RX phrasing

The diagram below illustrates the example setup described above.