Manual

19
How to use IR remote controller to remotely control the PTZ camera via Dante AV decoder:
1. Use the IR remote controller to control the PTZ camera directly aiming to the camera.
2. Go to camera OSD setting, set the IR-RECEIVE to OFF.
3. Dante Controller serial RS422 routing check.
• The 'RS-422' ancillary channel on the Bolin-PTZ-Camera-D220 receiver is subscribed to the equivalent
channels on the Bolin-Decoder-D10H transmitter.
These subscriptions would enable serial control RS-422 on the transmitter (decoder) via the Serial control
ports RS-422 on the receiver (camera).
• The 'RS-422' ancillary channel on the Bolin-Decoder-D10H receiver is subscribed to the equivalent
channels on the Bolin-PTZ-Camera-D220 transmitter.
These subscriptions would enable serial control RS-422 on the transmitter (camera) via the Serial control
ports RS-422 on the receiver (decoder).
• It is not needed to use IR subscription when you use Bolin Dante AV camera and Bolin Dante AV
decoder.
EXPOSURE
WHITE BALANCE
PICTURE 1
PICTURE 2
PAN TILT ZOOM
→SYSTEM
STATUS
OSD
PELCO ID 001
IR-RECEIVE OFF
PRESET SETTINGS
COLOR SPACE YUV422
FACTORY RESET
RELOAD PRESET 1 ON
VIDEO FMT 2160p60
SV: VOC260B40040AA008
SYSTEM MENU