Manual

18
Obtain Video Signal
Use Dante AV Decoder to obtain Dante AV Camera video stream
1. Use Cat6 network cable to connect Dante AV decoder and Dante AV camera to the same POE
network switch.
2. Connect Dante AV decoder’s HDMI to HDMI display device.
3. Use Cat6 network cable to connect the PC that installed Dante Controller to the same network switch.
4. Running the Dante Controller, check to subscribe video TX (camera HDMI video) to RX (decoder
HDMI video) connection.
5. Dante video will be routed to display on the HDMI monitor via Dante AV decoder.
6. You can set the video format of the Dante AV camera to the one you want to display.
Supported Video Resolutions
The Dante AV decoder supports the following video resolutions.
Video Resolution
Color space, chroma subsampling & pixel depth
Refresh (Hz)
VGA (640x480)
RGB 4:4:4 @ 8 bit
59.94/60
SVGA (800x600)
RGB 4:4:4 @ 8 bit
60
XGA (1024x768)
RGB 4:4:4 @ 8 bit
60
SXGA (1280x1024)
RGB 4:4:4 @ 8 bit
60
UXGA (1600x1200)
RGB 4:4:4 @ 8 bit
60
WUXGA (1920x1200)
RGB 4:4:4 @ 8 bit
60
480p (720x480)
RGB 4:4:4 @ 8/10/12 bit
YCbCr 4:4:4 @ 8/10/12 bit
YCbCr 4:2:2 @ 8/10/12 bit
59.94/60
576p (720x576)
50
HD (1280x720)
23.98/24/25/29.97/30/50/
59.94/60
Full HD (1920x1080)
UHD (3840x2160)
RGB 4:4:4 @ 8 bit
YCbCr 4:4:4 @ 8 bit
YCbCr 4:2:2 @ 8/10/12 bit
2160p (4096x2160)
Camera Control Methods through the Decoder
Dante AV decoder has two ways of controlling the Dante AV camera. This section describes ways of controlling
the camera with typical system examples and the required components of each system.
1. Use the Infrared Remote Controller to control
2. Use Keyboard Controller RS-422 to control.
Using Infrared Remote Controller via Decoder
Dante AV decoder is equipped with infrared receiver head, allowing control signals from the infrared controller
to be received and forwarded to the camera that has been installed at the other end point. This enables the
use of an infrared remote controller to control the Dante AV camera through the decoder.
The Dante AV camera may be installed at a remote site with the decoder placed in the control room. This
setup allows the administrator in the control room to be able to use the Dante AV decoder, to decode the
camera’s video stream, and output it to the HDMI monitor. Meanwhile, the same administrator can use
Infrared Remote Controller to control the remote location’s camera through the Dante AV decoder.
1. When Bolin Dante AV decoder is used, the decoder has camera IR receiver built in. At the remote site where
the decoder is connected to the displayer, use IR remote controller to control the PTZ camera via decoder.