User manual

USER MANUAL
20
Local rec Path: indicate recording save path.
Set channel size: Setup size for each channel on the screen.
Open Log function: The option allows you to open or close Log function. When
opening the function, you will find Log file for every operation through the local save path.
AVI Save: The option allows you to setup video size, video source and frame/sec.
AVI Codec: Select a AVI codec program to proceed video stream processing;
Please click [OK] key to save the above parameter setup.
2）．Click“ ” button to pop up the below window and input system
password, and system will prompt you if the connection is successful or not.
Note: Please firstly connect Hard-disk to DVR well before connecting network.
6.4 Working Mode
1）．Live Mode：After successful connection, click “ ” icon to enter into Live Mode,
and then click “ Play” button to display image. If you want to stop to monitoring, please click
“ pause” button to stop.
On Live mode, system could proceed PTZ control. Firstly you should setup PTZ protocol, Baud
rate and PTZ address on one channel, then enter into PTZ operation interface on DVR; next
double-click the camera you want to control. At this moment, you could proceed PTZ control by
clicking the PTZ button at the top of screen.
After successful connection, click [ ] icon to enter parameter setting of DVR.
Please note you could set almost all parameters except network set on parameter set menu.
When entering into menu, please not set up any parameters through net-view program to avoid any
confliction.