User manual

USER MANUAL

Move cursor to any time point on the schedule, and press numeric key 1

(always)/2(Motion)/3(Sensor)/4(off) on front panel or the corresponding icon of screen and

[menu] or [select] key to select record mode.

5.3.6 Network

Video Port: indicates network access port number, default value is 2200. You can

change the port number as per your actual situation.

Web Port: indicate protocol port number when visiting DVR via IE browse. Fault value is

8080. and you can change port number as per your actual situation.

IP: The IP address must be unique at the local area network.

Net mask: It refers to a subnet mask used to determine what subnet an IP address

belongs to a number that is used to identify a sub network so that IP address can be

recognized by a local area network.

Gateway: The Gateway is usually housed at the ISP. The gateway connects networks

that have different protocols. The Gateway address is provided by your ISP.

DDNS：Make use of fixed domain name to visit the DVR which is mapping dynamic IP

address of Router. Please refer to section 5.3.6.2 for detail set method

Email: When motion detected and sensor triggered, system will send out alarm email to

designated email address. Details setting method please refer to section 5.3.6.3.

Press[ESC] key to exit, and press [Enter] key to save your setting.

5.3.6.1 External Net Inflection

If you need to visit DVR via External net, you should setup the inflection of video port

IP Mode：This option allows you to set

system network type to DHCP or static. Once

you set to static allocation, you will manually

setup IP address, Gateway, Net Mask etc. If

set to dynamitic mode, system will have to

provide DHCP server, otherwise, DVR can’t

ture IP address.

◄►

at the public Router located in the DVR.

Firstly open the website of router and

enter into transmission ruleÆvirtual server to

setup service ports (included video port).IP

address of external net is same as the DVR

Transmission Rule

Virtual Server

Svc Port IP Add. Protocol Enable

2200 192.168.1.210 ALL √

Save Cancel