User manual

USER MANUAL
9
format is 120 frames, and HD1 format for 60 frames, and on PAL mode, total frame of CIF
for 100 frames, HD1 for 50 frames.
You could select to manually setup frame rate on GROUP mode, and on AUTO mode
system automatically allocate frames (Under this mode, you couldn’t modify the frames).
On NTSC mode, max frames for each channel should be 30 frames.
Press [◄or►] key to select channel, [▲or▼] key to modify the parameters,
[ENTER]key to save the modification and exit and [ESC] key to quit the modification and
exit.
5.3.3 Motion Detection
Motion Area：The option allows you to set motion detection area. Details please refer
to section 5.3.3.2.
Post Record Time: The option allows you to define the recording start time after
detecting motion, the value can be changed from 5 、10、15to 60 seconds or off.
Buzzer time: The option allows you to define how long buzzer will sound after
detecting motion. The value can be changed from 1 to 60 seconds or off.
Alarm time: The option allows you to define how long external alarm time will last after
detecting motion. The value can be changed from 1 to 60 seconds or off.
Motion trace: indicates whether screen will display the motion trace when detecting
motion. When motion detection is on and there is motion in detection area, the according
trace will display in red.
Press [ESC] key to exit menu, and if you want to save the setup, please press [Enter]
key.
5.3.3.1 Sensitivity
The lowest is 1, and the highest is 8, and fault value is 4.
After finishing the above set, press [Enter] key to save and exit the menu, and [ESC] key
Channel: Press [◄ or ►] key to select
channel. While selecting [ALL], it means
configuring all channels at the same time.
Motion enable: Turn on or off motion detection
function.
Sensitivity: The option allows you to set
sensitivity of motion detection. Details please
refer to section 5.3.3.1.
Press [Enter] button to enter into Sensitivity
Menu (shown as left picture).
Sensitivity levels include 1- 8.