User manual

USER MANUAL
7
5.3.1 Camera
Title: the option allows you to define the name of each camera. Details please refer
5.3.1.2.
PTZ Protocol: Press [◄ or ►] key to select protocol, from PELCO-D to PELCO-P.
PTZ address: Press [◄ or ►] key or numeric keys to adjust physical address of PTZ
camera, the value can be changed from 0 to 255.
Baud rate: Press [◄ or ►] key to adjust baud rate, including 600,1200,1800,2400,4800,
9600 and 19200.
Event popup: When alarm is triggered for one channel, DVR will make this channel
enlarge to full screen in designated time, the time can be changed from 1 to 10 seconds or
off.
Rotation time: Define the dwell time for single channel full screen display when rotation
function is turned on. You can use [◄ or ►] key to select the time value, and rotation time
can be changed from 1 to 10 seconds or off.
Press [Enter] key to save the parameters you want to change, and [ESC] key to quit
menu.
5.3.1.1 Color Setup
and exit the setup and [ESC] key to quit the setup.
You can adjust the parameters freely as per actual situation to reach the best display
effect.
Channel: Press [◄ or ►] key to select
channel. When selecting [ALL], that means
configuring all channels at the same time.
Color: In order to get the best video
image, the option allows you to adjust
parameters such as brightness, saturation,
contrast and hue etc. Details please refer
to Section 5.3.1.1.
When entering into the [Color] menu, you
can adjust parameter of Contrast/Brightness/
Hue/Saturation. The level is from 0 to 99.The
default value is 50.
Press [◄or►] key or numeric keys to
adjust the parameters, [Enter] key to save