User`s manual
S2000-К Programming
31 www.bolid.com
NETWORK CONTROLLER SETTINGS
The network controller can be programmed either by means of the PProg Console Configuration Tool
(if an S2000/S2000M/S2000/L is used as the network controller) or with the help of the Orion Data-
base Administrator Software (if the system operates under an Orion Software). Full description of the
network controller programming process can be found in the Manual for the network controller being
in use.
To program a network controller for operating an S2000-K keypad, the keypad descriptor along with
its network address is to be enrolled to the controller database (see below).
If the S2000-K keypad is to be used for entering user commands, do the following:
ØProgram in the controller database a list of users along with their authenticators (digital PIN
codes or codes of access devices such as iButtons or Proximity cards) which are enabled to
manage the system from the keypad, and
ØProgram the specific rights of these users to control specific partitions of the Orion system (Ac-
cess Groups), and
ØEnable managing the partitions by means the S2000-K keypad in question (see below)
If the S2000-K keypad is to be used for visualizing system events and indicating alarms, adjust the
mechanism of translating system events from the network controller to the S2000-K (see below).
Further in this Manual we describe some procedures of programming an S2000/S2000M/S2000L
console with the help of PProg Console Programming Tool. These and other common procedures are
described more closely in the Manual of the console being in use (or in the Database Administrator
Manual if the system operates under the Orion Software).
A fresh version of the PProg can be downloaded from the Bolid site at the address of www.bolid.com
.
How to enroll the S2000-К to the Console Database Using PProg
1. Run PProg.exe and find the devices connected to the computer by means of the
S2000 ® Read Configuration command. As a result, the program outputs the list of found de-
vices along with their addresses, types, and version numbers.
2. Add the S2000-K descriptor to the device tree by dragging them from the Search window and
dropping on the Devices window (see Figure 4). If necessary, assign the keypad to a textual de-
scription or revise its other parameters in the Inspector (Device) window.