User`s manual

S2000-К Programming
29 www.bolid.com
To reach the S2000-K settings you can also read the keypad configuration from a data storage device
using the File ® Load Configuration File command (or the <F3> button on the PC keyboard, or the
tool).
Moreover, you can create a new configuration file for the S2000-К by means of the
File ® New Configuration command (or <Ctrl+N> buttons on the PC keyboard, or the
tool
from the Toolbar).
The amended or newly created configuration can be:
Loaded into the keypad memory
, Device ® Write Configuration to This Device
Loaded into the memory of another
S2000-K connected to the PC, while
specifying the new network address
Device ® Write Configuration to Another Device
Written into a file
having an internal UProg format with
the .cnu extension
, <F2>, File ® Save Configuration to File
Written as a text into an MS Word
file
, «File» ® «Экспорт конфигурации в Microsoft Word»
The S2000-К stores its settings in its non-volatile memory.
To identify the S2000-K keypad within a group of devices of an Orion system, the keypad must be
assigned to a unique number within the RS-485 interface line ¾ the network address ranged from 1
to 127 (see below). The factory setting for the network address of each Orion system device is 127.
If the keypad is supposed to be used for displaying system events and indicating system alarms re-
motely, this one must be programmed so as it can receive data from the network controller (see be-
low).
Programming the Network Address of the S2000-К
The network address of the S2000-К can also be programmed by means of S2000(M) console tools
as described in the Manual of the console being in use.
To define the network address of the S2000-К by means of the UProg Configuration Tool, select the
Device ® Change Device Address command and enter the proper address into the appeared dialog
box).