User`s manual

Orion ISS
www.bolid.com 28
After installing the S2000-K, set keypad configuration parameters and modify the network controller
database in order to use the S2000-K as a part of the Orion system.
To program the S2000-K connect it to a personal computer via one of the Bolid manufactured inter-
face converters such as S2000-PI, PI-GR, S2000(M) in the Converter Mode, S2000-USB, USB-
RS485, etc.. Install the Orion Device Configuration Tool, the UProg, on the computer. A fresh version
of the UProg can be downloaded from the site of the Bolid Company at the address of
www.bolid.com
.
The network address of the S2000-K can also be programmed with the help of the tools of the net-
work controller being in use.
To program the network controller use either the PProg Console Programming Tool (if an
S2000/S2000M/S2000L controls the system) or Database Administrator Software tools (if the system
operates under the Orion Software).
PROGRAMMING THE KEYPAD
The S2000-K keypad can be programmed by means of the UProg Configuration Tool.
To install the UProg, download its archive to the PC and unpack it to the relevant directory (for exam-
ple, the C:/Program Files/UProg). Run the UProg.exe file or create its shortcut on the desktop.
1. Find the devices connected to the computer by using the Device ® Read Device Configuration
command, or pressing <Ctrl+F3>, or selecting
on the Toolbar. Select the proper number
of the COM port the keypad is connected to in the Search Devices window.
2. Upon finding all the connected devices UProg outputs the list of the devices along with their net-
work addresses and version numbers on the display. Select the relevant S2000-K keypad and
press the Select command.
Figure 3
3. The UProg will display the current settings of the S2000-K which can be revised (see Figure 3).