Manual

STARTING/STOPPING INSTRUCTIONS
STARTING INSTRUCTIONS
WARNING: Operate this unit only in a well- yen- 1
tilated outdoor area. Carbon monoxide exhaust I
fumes can be lethal in a confined area. J
WARNING: Avoid accidental starting. Make sure
you are in th e starting position when pulling the
starter rope (Fig. 8). To avoid serious injury, the
operator and unit must bein a stab!e position
while starting.
/
Start / Stop Control
1. Mix gas with oil. Fill fuel tank with fuel/oil mixture. Refer
to Oil and Fuel Mixing Instructions.
2. Put the Start/Stop Control in the START (I) position
(Fig.6).
3. Fully pressand release the primer bulb I0 times, slowly,
until FUELIS VISIBLE IN THE PRIMERBULB(Fig. 7). If
you can't see fuel inthe bulb, press and release the bulb
as many times as ittakes before you can see fuel in it.
4. Placethe choke lever inthe FULLchoke position (A H )
(Fig. 7).
5. Stand between the handlebars and support the unit by
placing your left foot on the wheel bracket assembly and
gripping the handlebar grip with your right hand (Fig. 8).
NOTE: Tilt the unit back slightly to bring the tines off
the ground when starting.
6. While squeezing the throttle control to the wide open
(full throttle) position, grasp the starter rope grip with
your left hand and pull the starter rope briskly 5 times. If
the engine attempts to run before the fifth pull, proceed
to step 7.
NOTE: The unit will not run in the FULL choke position
(AN).
7. Place the choke lever in the PARTIAL choke position
(g I_1 ) (Fig. 7).
8. Pull starter rope briskly 1 to 3 times to start the engine
(Fig.8).
NOTE: Squeeze the throttle control until the engine
has started and warmed up.
9. If the engine does not start, repeat steps 3 through 8.
NOTE: If the engine floods while trying to start, place
the choke lever in the RUN position (C IH )
(Fig. 7). Squeeze the throttle control. Pull the
starter rope briskly. The engine should start
within three (3) to eight (8) pulls.
10. Squeeze the throttle control to warm up engine for 5 to
10 seconds. Place the choke lever in the RUN position
(cIH) (Fig.7).
NOTE: Choking is unnecessary when starting a warm
engine. Put the On/Off Stop Control in the
START (I) position (Fig. 6), and start in PARTIAL
choke position (BIxl ) (Fig.7).
Partial Position (B) I Fig. 7
Full Choke
Position (A)
Position (C)
Choke Control
Primer Bulb
Starter
Rope
Throttle
Control
J#j
STOPPING INSTRUCTIONS
1. Releaseyour hand from the throttle control (Fig.8).
Allow the engine to cool down by idling.
2. Put the On/Off Stop Control in the STOP (O) position
(Fig.6).
9
m
m