User manual

OSD Menu Functions Note: Software updates may enhance these menu offerings (0.45.70 and later).
Left Menu
NOTE:
Monitor factory signal
calibration settings
are:
50 / 50 / 50 / 0 / 0
Backlight slider can
be used to calibrate
monitor brightness to
SMPTE 25 foot-
lamberts value.
Many menu functions
can have speed
access with Hot Keys
(see HK1 and HK2 in
Utilities Menu).
Picture Menu Note: ">" indicates a sub-menu (use button to Enter)
Brightness brightness level (picture blacks level) (100 steps)
Contrast contrast level (picture whites level) (100 steps)
Saturation colors saturation (100 steps)
Hue hue of colors (flesh tones) (100 steps)
Sharpness* sharpness of picture (30 steps)
Backlight panel lamp brightness (10 steps)
Position > Arrow Keys : Adjust image position on screen (VGA input only)
Aspect Size > Fill Screen : Enable full screen expansion for lower resolutions
Fill to Aspect Ratio: Enable automatic screen sizing according to
source image's aspect ratio (height or width)
4:3 : sizes image to 4:3 format
16:9 : sizes image to 16:9 format
16:10 : sizes image to 16:10 format
2.35:1 : sizes image to 2.35:1 ratio format
2:1 : sizes image to 2:1 ratio format
1:1 : displays the image in native image resolution with-
out image expansion/reduction (pixel-for-pixel)
Custom Sizing :
(Displayed for HD- or SD-SDI, Composite, and S-Video sources)
Overscan : Image is magnified, edges of image not displayed
Normal : All of image content is visible on the screen
Custom/Underscan : Image size is variable, shifted
H Size
V Size
H Pan
V Pan
Blue Only Turns off the red and green channels for calibration of
Saturation and Hue using test signal (75% SMPTE color
bars or equivalent).
*
Displayed for HD- or SD-SDI, Composite, and S-Video sources
Center Menu
Center Menu selects
the main and PiP
inputs.
PiP Source is Inserted
video for both Picture in
Picture [PiP] and Picture
by Picture [PbP] modes)
Input Select Menu Push Menu button twice within 1/2 second to directly access this menu.
Note: Only installed inputs for this monitor model are displayed, and then only
if enabled in the Utilities Menu under Setup, Auto Source Seek.
HD/SD SDI 1
HD/SD SDI 2
VGA
DVI
HD Component
Composite 1
Composite 2
S-Video
PiP >
PiP Source (See PiP group selection limitations note on page 9 )
OFF / HD/SD SDI 1 / HD/SD SDI 2 / VGA / DVI / HD Component / Composite 1 / Composite 2 / S-Video / SD Component / OFF
PiP Size > Off / Small / Medium / Large / PbP (Picture by Picture)
PiP Position > Arrow Keys: Adjust PiP window position within screen
Pip Swap > [Enter], Trades contents of main screen and PiP window
Pip Auto Off Auto remove PiP window if signal is lost (10 sec)
10b VIEWPORT Manual dhd/xd/d 122008 6