Specifications

ManualsBrandsBogen ManualsStereo SystemRM-350D

109

Order Toll Free

1-800-543-4330,

FAX

1-800-765-6960

109

Order Toll Free

1-800-543-4330

Fax

1-800-765-6960

NET 30

Terms

Professional

Audio

section

HeadAMP4

Headphone

Amplifier

This amplifier is

ideal when multiple

headphones need to be

driven from one output. This unit

features four individual headphone outputs, with

both

⁄4" and 3.5mm outputs, and their own level

control. Input accepts either size connector as well.

The HeadAmp4 will connect to virtually any source,

and drive any headphone configuration including

studio phones, in-ear monitors or custom ear pieces

or any combination of the above. Features: •Requires

12VDC, AC adaptor included •Dimensions: 3.75" (H) x

2.875" (W) x 1.5" (D)

Order # (ea.)

555-2722 $49.00

AVDirect

Multi-Input

Direct Box

Ideal in applications

where iPods, laptops,

consumer DVD players,

or home theater components need to be

connected to a single XLR mic level input. This unit

will accept virtually any input connection and level,

including amplified speaker outputs, and provides

balanced XLR mic level output. Features: •L/R RCA

line inputs •3.5mm and

⁄4" stereo line level inputs •

⁄4"

and push terminal speaker level inputs •Switchable

4.8KHz high cut filter •Ground lift switch •Variable

level control •Full 20Hz~20KHz frequency response

•Dimensions: 1.75" (H) x 4.2" (W) x 3.5" (D)

Order # (ea.)

555-7677 $45.00

Tube Mic

Preamp

w/USB Output

Professional quality

audio interface allows

connection of mic, instrument,

and line level signals to standard

line level inputs as well as USB computer inputs.

Features: •USB output •Stackable extruded

aluminum chassis •Precision LED level metering

circuitry •Ultra low noise discrete microphone

preamp front end handles a wide range of input

signal levels •High impedance

⁄4" instrument input

•High-quality 12AX7A tube •Switch selectable

high-pass filter removes very low frequency rumble

and wind noise •48V phantom power is available

•Phase invert switch •Up to 70dB of gain •Fast FET

limiter to prevent overload •Switch selectable input

impedance •Variable input and output level controls

•Requires 10VAC, 700mA •AC adaptor included

•Dimensions: 1.75" (H) x 5.9" (W) x 6.5" (D)

•Model #TUBE-MPPSUSB

Order # (ea.)

555-8432 $99.00

X-Direct

Active

Direct Box

High-quality

active

interface lets you

connect instrument,

line, or speaker level signals

to a mixer or other balanced input. High impedance,

single-ended (unbalanced)

⁄4" input is buffered and

converted, by very low noise active electronics, into

an isolated, balanced low impedance signal source.

Input-attenuator switches allow selection of 0dB,

-20dB or -40dB for a wide range of signal levels and

the input-thru jack allows tapping off of the signal

chain. The ground-lift switch separates input and

output signal grounds to isolate two systems, reducing

hum and ground-loop noise. Additional features:

•Switchable 30KHz low-pass bessel filter to cut out

high frequency RF and electrical interference •Phase

invert switch •Compact black anodized aluminum

case •9V battery or phantom powered (auto sensing)

operation Specifications: •Frequency response:

10Hz~100KHz •THD: <0.05% •Maximum output

level: +6dBu, +14dBu (phantom powered) •Maximum

input level: +4/+24/+44dBu •Dynamic range: >100dB

typical •Input and input-thru connection:

⁄4"

unbalanced, 50Kohm •Output connection: XLR male,

600ohm •Dimensions: 1.75" (H) x 4.2" (W) x 3.5" (D)

Order # Model (ea.)

555-7680 X-Direct $29.00

Z-Direct

Passive

Direct Box

High-quality

passive

interface lets you

connect instrument,

line, or speaker level signals

to a mixer or other balanced input. High impedance,

single-ended (unbalanced)

⁄4

" input is converted into

an isolated, balanced low impedance signal source.

The internal audio transformer has extremely flat

and wide frequency response and can handle high

signal levels. Input-attenuator switches allow

selection of 0dB, -20dB or -40dB for a wide range of

signal levels and the input-thru jack allows tapping

off of the signal chain. The ground-lift switch

separates input and output signal grounds to isolate

two systems, reducing hum and ground-loop noise.

Additional features: •Switchable 30KHz low-pass

bessel filter to cut out high frequency RF and

electrical interference •Phase invert switch •Compact

black anodized aluminum case Specifications:

•Frequency response: 10Hz~50KHz •THD: 0.01%

•Input and input-thru connection:

⁄4" unbalanced,

50Kohm •Output connection: XLR male, 600ohm

•Dimensions: 1.75" (H) x 4.2" (W) x 3.5" (D)

Order # Model (ea.)

555-7675 Z-Direct $19.00

Project

Series Tube

Microphone

Preamplifier

Considered the

world’s most popular external microphone preamp,

the TUBE–MP utilizes a hand picked 12AX7

preamplifier tube, to add warmth and fatness to a

signal while maintaining exceptionally low noise and

high quality. Designed for use with a microphone, it

also functions as an exceptional direct box, impedance

matching, amplifying and improving the sound of any

device plugged into it. Features: •Extremely low

noise discrete front end •Up to 70dB of clean, musical

gain •High output signal drive capability •Selectable

input impedance •Switchable 48V phantom power

•Switchable FET limiter •XLR and

⁄4" inputs and

outputs •Phase invert selector •High cut selector

•Variable input and output controls Specifications:

•Frequency response: 10Hz~40KHz •Dynamic range:

>100dB (20Hz~20KHz) •THD: <0.05% •Dimensions:

1.75" (H) x 5.9" (W) x 6.5" (D) •Power requirements:

10VAC, AC adaptor included

Order # (ea.)

555-8430 $65.00

TUBE-MP Microphone

Preamplifier

Considered the world’s