5/11/15 10:11 AM we 1 Orbit Pendant Speaker OOPS (Dark Gray), OOPS (Off-White) Installation and Use Manual © 2003-2014 Biogen Communications, Inc. All rights reserved. Specifications subject to change without notice.
5/11/15 10:11 AM we 2 The Biogen OPS Pendant Loudspeaker is a full-range, wide dispersion system providing overhead sound coverage where ceiling structures are high but the sound needs to be closer to the audience/listener. An optional cable kit (CK10), suitable for safety or main drop cable, is available. Settings for both 70V and 100V high-impedance systems, as well as a low-impedance (16-ohm) position, are provided.
5/11/15 10:11 AM we 3 OPS Front Drawing 1. Tap Selection Switch 2. Coaxial Driver Assembly 3. Grille Retention Slot 4. Bass Tuning Vent (x2) 5. Perforated Steel Grille OPS Front Drawing (rifle partially shown) OPS Rear Drawing 6. Snap-Lock Input Connector 7. Suspension Points (x3) 8.
5/11/15 10:11 AM we 4 Select the power level using the front-mounted selector switch. The speaker grille must be removed prior to selecting the power level. See Speaker Grille Installation & Removal section for proper grille removal procedures. Selecting Power Level The front-mounted selector switch {under grille) is used to set the appropriate power level or impedance for your system. Using a small flat-blade screwdriver, turn the knob until the slot points to the power level you require.
* Speaker Wi 5/11/15 10:11 AM we 5 Wiring is terminated at a snap-lock input — connector. There are two positive and two EN negative terminals to accommodate daisy chaining of speakers in a system. All wiring J root should be done prior to installation and then Ng EMERGENT\ plugged into the rear of the OPS. / Lig 1 Daisy-Chaining The Slops's snap-lock input connector allows \ / for easy daisy-chaining of speakers by providing a second terminal of each polarity.
5/11/15 10:11 AM we 8 Speaker Installation Speaker Assembly 1. Screw one nut onto each of the three (3) eye bolts. These nuts are used as spacers and should be threaded on as far as they can go. Screw in eye bolts with captured cable sections inch the three (3) threaded anchor points. Make these connections secure but do not over tighten. Snap the loops of the three (3) free ends of the cable sections into the quick-snap clip. Connect the quick-snap clip to the drop cable loop (not included).
Specifications fl CATIONS Frequency Response (-10 a8)" | 5/11/15 10:11 kHz MDT Metal-Alloy Cone LF Driver (MLS Voice Coll Centering System) HF Driver 20 mm C4") Poly carbonate Dome Sensitivity (IW m) 89.
5/11/15 10:11 AM we 8 The Biogen ORBIT Pendant Speaker, Model OPP, Is warranted to be free from defects In material or workmanship for five (5) years from the date of sale to the original purchaser. Any part of the product covered by this warranty that, with normal installation and use, becomes defective will be repaired or replaced by Biogen, at our option, provided the product is shipped insured and prepaid to: Biogen Factory Service Department, 4570 Shelby Alr Drive, Suite 11, Memphis, TN 38118 USA.
