NR100 Night Ringer Installation & Use Manual © 2009 Bogen Communications, Inc. All rights reserved. Specifications subject to change without notice.
THE FOLLOWING INFORMATION IS REQUIRED BY PART 68 OF FCC RULES TO BE SUPPLIED TO THE PURCHASER OF REGISTERED EQUIPMENT. This equipment complies with part 68 of FCC rules. The FCC registration number and ringer equivalence number are printed on the front panel of this equipment. You must, upon request, provide this information to your telephone company. If this equipment causes harm to the telephone network, the telephone company may discontinue your service temporarily.
Terminal Connections TEL RING T&R CONTACT RING A&B POWER SUPPLY +24 & -24 Connects to telephone line and activates the NR100 upon detection of a telephone ring signal. Activates the NR100 when shorted through a normally-open dry contact (requires suitable multi-line interface). Connects to 24V DC supply capable of supplying 25mA. Bogen PRS2403 Power Supply is recommended. Connect power supply only as shown in Figures 1 or 2. Do not ground either of the power supply terminals.
Specifications Registration No. under Part 68 of FCC Rules: CD23CH-17566-KX-N Ringer Equivalency:1.
