Installation Manual

Viewing and Understanding LEDs

Two LEDs appear on the front of the amplier. One is labeled

POWER and appears as solid red during initial power up,

ashes green during a boot sequence, and appears solid green

when fully booted.

The STATUS LED uses the following indicators to provide

information about the appliance:

• Flashing red – No network connection found.

• Solid blue – The amplier is in an uninitialized state and is

not associated to a server. (The server may be in a discovery

mode.)

• Solid green – The

amplier is registered to

a Nyquist server and is in

normal operation.

• Flashing green – The

amplier has an IP

address but is not

registered with the

Nyquist server.

• Solid red – The amplier needs to be rebooted or reset so

that the Nyquist application can resume.

• Flashing blue – The amplier is updating.

Clipping, Protection, and Temperature Indicators

In addition to the LEDs that appear on the actual appliance,

separate amplier module signal clipping, protection mode,

and temperature status indicators appear in the Nyquist

1200 MacArthur Blvd. Suite 304, Mahwah, NJ 07430

1-800-999-2809