Installation Manual

The combined total power of each speaker tap must not

exceed 80% of the rated amplier power in either Bridged

70V/25V/8Ω mode or 2CH 25V/8/4Ω mode.

Failure to observe minimum speaker impedance will cause

the amplier to self protect until the speaker conguration

is corrected.

6. If using Line Input, route the input.

The amplier uses a balanced line level (up to 2V RMS) ana-

log audio input. You can use either XLR or Phoenix (but not

both) as the input.

This input can be routed to either or both amplier channels,

depending on the setting of the Amplier Mode switch.

7. Plug the power line cord into the power source.

8. Toggle the Power switch to the On position.

9. For information about conguring the amplier for the

Nyquist system, refer to the Nyquist Audio Power Ampliers

Conguration Manual.

Power Ratings

The NQ-A2060 can provide 60 Watts into two separate chan-

nels into 25V, 8Ω, or 4Ω, or 120 Watts Bridged (one channel) into

70V, 25V, or 8Ω load congurations.

The NQ-A2120 can provide 120 Watts into two separate chan-

nels into 25V, 8Ω, or 4Ω, or 240 Watts Bridged (one channel) into

70V, 25V, or 8Ω load congurations.

1200 MacArthur Blvd. Suite 304, Mahwah, NJ 07430

1-800-999-2809