Installation Manual

Bridged mode is typically used when higher power,

single channel operation with a high impedance

loudspeaker load is desired. A typical use-case would

be for 70V or 25V loudspeaker runs, where the total

load is no less than 8Ω.

2 Channel mode is typically used for 8Ω or 4Ω

loudspeakers runs. This mode allows the two amplier

channels to operate independently.

5. Connect the loudspeaker wires to the Amplier

Output Terminals, which are labeled A +/- and B +/-,

as appropriate for the desired mode of operation (see

Figures 1 and 2).

Figure 1. Bridged Wiring Diagram

Bridged mode operation requires the speaker wires to

be connected across a single, different terminal on each

channel (A+ and B-). (See Figure 1.)

1200 MacArthur Blvd. Suite 304, Mahwah, NJ 07430

1-800-999-2809