Installation Manual

Installation

To install the Audio Power Amplier:

1. Ensure the POWER switch is in the off position.

2. Connect the universal mains power line cord into the

amplier.

3. Connect a Cat5 type cable into the amplier’s Ethernet port

and ensure the other end of the cable is correctly connected

to your network.

4. Set the Amplier Mode switch to the desired setting.

This amplier can be congured for single-channel bridged

mode (aka bridged-tied load) operation for 70V/25V/8Ω

applications, or 2-channel (mono) operation for 25V/8Ω/4Ω

applications. The Amplier Mode switch is used in

conjunction with the Bridged Signal routing setting in the

system console.

1200 MacArthur Blvd. Suite 304, Mahwah, NJ 07430

1-800-999-2809

WARNING:

The apparatus shall be connected to a mains socket

outlet with

a protective earthing connection.

To reduce the risk of re or electric shock, do not ex-

pose this apparatus to rain or moisture.

The apparatus shall not be exposed to dripping or

splashing and no objects lled with liquids, such as

vases, shall be placed on the apparatus.

Where the mains plug or an appliance coupler is used

as the disconnect device, the disconnect device shall

remain readily operable.