Spec Sheet

Power Output 2-Ch. Mode (per Ch.) 60W @ 25V/4 ohms 120W @ 25V/4 ohms 300W @ 25V/4 ohms
Power Output 1-Ch. Bridged Mode (per Ch.) 120W @ 70V/25V/8 ohms 240W @ 70V/25V/8 ohms 600W @ 70V/25V/8 ohms
Line-In Sensitivity (Gain min./max.) Continuously variable from 2V to 0.1V RMS
S/N Ratio (20 kHz BW) 97 dB
Power Output Bandwidth 20 Hz- 20 kHz < .03% THD+N
THD+N @ 1 kHz rated power < .03%
Rated Load Impedance (min. per Ch.) 8 ohms Bridged / 4 ohms Non-Bridged
Frequency Response @ 1 Watt 20 Hz - 20 kHz +/- 0.25 dB
Class of Operation Class D
Connectors Power 10A Line Cord C14 IEC Inlet
Input Balanced 3-pin Phoenix Plug/Header, Balanced 3-pin Neutrik XLR, RJ45, USB 2.0 Type A
Output 4-pin “touch proof” Phoenix Plug/Header
Line Inputs 10k ohm electronically balanced, 3-pin Phoenix and 3-pin Neutrik XLR
AC Input Voltage Range 85 VAC to 265 VAC 50/60 Hz
Maximum AC Current 2A 3A 6A
Indicators Status & Power LEDs (front) / Network LEDs (rear)
Operating Temperature Range -15 C to +40 C
Thermal Emissions (Full Power) 90 BTU/hr. 135 BTU/hr. 225 BTU/hr.
Cooling Convection
Protection RF, DC, Low Frequency, Thermal, Low Impedance, Short Circuit, Clip Limiting
DSP Based Audio Features 16-band Graphic Equalizer; Signal Present and Clip Monitor; Adjustable High Pass, Low Pass,
and Bandpass Filters; Noise Gate; Compressor/Limiter; 7-band Parametric Equalizer
Special Features Sleep Mode (defeatable), Power Factor Correction (PFC), 89% Amplifier Eciency,
On/O Muting, Bridge Mode Switch
Networking Cat5 or better 10/100 network connectivity to Bogen's Nyquist network
Product Weight 4.4 lbs. 4.4 lbs. 6.4 lbs.
Physical Dimensions: 1/2 Rack Width x 1RU
*
1/2 Rack Width x 2RU
**
*
Single Rack Space (1RU) 8.00” W x 1.70” H x 13.48” D
(Depth includes Phoenix connectors; width is without rack mount brackets attached; height excludes rubber mounting feet)
** Double Rack Space (2RU)
8.00” W x 3.43” H x 13.48” D
(Depth includes Phoenix connectors; width is without rack mount brackets attached; height excludes rubber mounting feet)
NQ-A2060-G2
NQ-A2120-G2 NQ-A2300-G2
1200 MacArthur Blvd., Suite 304, Mahwah, NJ 07430 • 1-800-999-2809
www.bogen.com
© Copyright 2020, Bogen Communications, Inc. 740-00152B 2109
+ –
G
+ –
G
LINE INPUT 1
LINE INPUT 2
+ –
G
+ –
G
LINE
INPUT 1
LINE
INPUT 2
TECHNICAL
SPECIFICATIONS
Limited Warranty, Exclusion of Certain Damages
The NQ-A2060-G2, NQ-A2120-G2, NQ-A2300-G2 are warranted to be free from defects in materials and workmanship for ve (5) years from the date of sale to the original purchaser. Any part of the
product covered by this warranty that, with normal installation and use, becomes defective (as conrmed by Bogen upon inspection) during the warranty period will be repaired or replaced by Bogen, at Bogen’s
option, with new or refurbished product, provided the product is shipped insured and prepaid to: Bogen Factory Service Department: 4570 Shelby Air Drive, Suite 11, Memphis, TN 38118, USA. Repaired or replace-
ment product(s) will be returned to you freight prepaid. This warranty does not extend to any of our products that have been subjected to abuse, misuse, improper storage, neglect, accident, improper installation
or have been modied or repaired or altered in any manner whatsoever, or where the serial number or date code has been removed or defaced.
THE FOREGOING LIMITED WARRANTY IS BOGEN’S SOLE AND EXCLUSIVE WARRANTY AND THE PURCHASER’S SOLE AND EXCLUSIVE REMEDY. BOGEN MAKES NO OTHER WARRANTIES OF ANY KIND, EITHER
EXPRESS OR IMPLIED, AND ALL IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ARE HEREBY DISCLAIMED AND EXCLUDED TO THE MAXIMUM EXTENT ALLOWABLE BY
LAW. Bogen’s liability arising out of the manufacture, sale or supplying of products or their use or disposition, whether based upon warranty, contract, tort or otherwise, shall be limited to the price of the product.
IN NO EVENT SHALL BOGEN BE LIABLE FOR SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, LOSS OF PROFITS, LOSS OF DATA OR LOSS OF USE DAMAGES) ARISING
OUT OF THE MANUFACTURE, SALE OR SUPPLYING OF PRODUCTS, EVEN IF BOGEN HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES OR LOSSES. Some States do not allow the exclusion or limitation
of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specic legal rights, and you may also have other rights which vary from State to State.
Products that are out of warranty will also be repaired by Bogen Factory Service Department -- same address as above or call 201-934-8500, at owner’s expense. Returned products which do not qualify for
warranty service, may be repaired or replaced at Bogen’s option with a previously repaired or refurbished items. The parts and labor involved in these repairs are warranted for 90 days when repaired by the
Bogen Factory Service Department. All parts and labor charges as well as shipping charges will be at the owner’s expense.
All returns require a Return Authorization number. For most ecient warranty or repair service, please include a description of the failure.
09/2021
Models NQ-A2060-G2
and NQ-A2120-G2
Front/Rear Panels
Model NQ-A2300-G2 Front/Rear Panels