Manual 4/20/15 2:04 PM Page 1 BOGON. High-Fidelity, Small-Footprint Speaker Model HFSF1 Installation and Use Manual © 2008, 2015 Biogen Communications, Inc. All rights reserved. Specifications subject to change without notice.
Manual 4/20/15 2:04 PM Page 2 duct Description Thank you for choosing Biogen's High-Fidelity, Small-Footprint Loudspeaker. Please familiarize yourself with the product by reading and reviewing the descriptions and diagrams In this manual. Biogen's coaxial 2-way small footprint selling speaker delvers unsurpassed performance and value. The HFSF1's steel back can and front exit tuned venting allow for extended bass response, enhancing the quality and Intelligibility of both speech and muse.
8 2:04 PM Page 3 Front Drawing (grille removed) 1. Bass Tuning Vent 2. Coaxial Driver Assembly 3. Grille Retention Groove 4. Mounting Clamp Screws (x3) 5. Power Tap Selection Switch Side Drawing 6. Metal Back Can + 7. Snap-Lock Input Connector 8. Terminal Cover 9. Safety cable attachment point 10. Mounting Clamps (x3) Rear Drawing (close up) 11. Terminal Cover (shown Installed} 12. Consult Knockout 13. Wire Exit Slot 14.
Manual 4/20/15 2:04 PM Page 4 installation Important Notes The HFSF1 can be installed in a variety of ceiling environments. The use of the TBS (Tile Bridge Support) accessory may be desired. For suspended ceilings, the use of both the TBS Lie Bridge and CK Safety Cable Is strongly recommended to help support and distribute the weight of the speaker. The HFSF1 requires a minimum of of vertical clearance between the front of the mounting surface and any other structure for the speaker to fit.
8 2:04 PM Page 5 taker Wiring All wiring should be done prior to Installation and then plugged into the rear of the speaker. TT Wiring Is terminated at a snap-lock Input cony ~ sector. There are two positive and two negative n arm terminals to accommodate daisy-chalning of CE NN speakers in a system. / Ney NTs | Daley-Chaining lL [ S The snap-lock input connector allows for easy daisy-chalning of speakers by providing a \ second terminal of each polarity.
8 2:04 PM Page 8 The front-mounts selector switch Is used to set the appropriate power level or impedance for your system. Using your fingers or a small, fiat blade screwdriver, turn the knob until the pointer Indicates the power level you aquaculture. 70V Systems Power setting scales for 70V systems are labeled on the speaker. 16-ohm Systems The fully counterclockwise position of the setting switch Is the 16-ohm position.
[= D_HFSF1 Manual pa 2:04 PM Page 7 Specifications Frequency Responds (-10 dB)" kHz LF Driver 4" Polypropylene Cons HF Driver 3/4” Poly carbonate Dome Sensitivity (1W/1m)" 86 dbl Dispersion 150 degrees Power Input (Max.
2:04 PM Page 8 Accessories TBS (Lie Bridge Support) The TBS is a combination tile bridge and support bracket that assists in securing the HFSF1, and in distributing the weight of the speaker in various types of installations. CK (Cable Kit, 10%} The CK Is a 10-foot cable with one looped end and an adjustable cable clamp. kt Is suitable for use as a safety cable.
