Data Sheet

The Bogen BPA60 solid-state power amplifier has
been designed to fulfill the power amplification
requirements of professional and commercial sound
systems. The Model BPA60 supplies 60 watts RMS
output. Total harmonic distortion is less than 2% at
rated output from 50Hz to 15 kHz.
Input impedances for the BPA60 are: high-imped-
ance (50k-ohms) unbalanced; and low-impedance
(500/600 ohms, balanced or unbalanced) with
accessory transformer Model TL600. Line-bridging
may be achieved with accessory transformer Model
TL100. Hum and noise are at least 85dB below
rated output.
The BPA60 amplifier may be driven from an amplifi-
er that provides a 25- or 70-volt output (with WMT1A
accessory). Output impedances for the BPA60 are:
8-ohm/25V, 16-ohm, 25VCT and 70V. Output regu-
lation is better than 2dB from no load to full load.
The BPA60 amplifier is thermally protected to pre-
vent damage due to excessive temperatures.
Additional protection is provided by transient protec-
tion diodes and an electrical circuit breaker.
An illuminated on/off power switch is located on the
front panel. An input level control, circuit breaker
reset, lo-cut filter switch, and auxiliary receptacle are
located on the rear panel. A rack panel kit (RPK53)
is available for mounting the amplifier in a 19-inch
equipment rack.
Power Amplifier
Model BPA60
• 60 watts rated power
• Distortion less than 2% THD
• Transient protection diodes
• Frequency response -2dB from 20Hz to 20kHz
• Multiple output voltages/impedances available
• Resettable circuit breaker; thermally protected
Features
Description
Specifications subject to change without notice.
© 1995 Bogen Communications, Inc.
Part No. 54-7609-06C 1010