TM-2030 Technical Manual
Copy this table and use it for recording the TriMetric TM-2030 History data. This data
can be helpful to a technician trying to diagnose a problem with your system, or to verify
that it appears to be operating normally. Also copy the data from program modes P1, P2
and P3 and copy it to the second chart at bottom:
To access this data:
1. Set “Operating level” to L2 or L3 using program P7
2. Push and hold “SELECT” down and watch display for “H1.1”, then quickly release SELECT. If you miss
the first time, just repeat until you succeed.
3. You will now observe data at “H1.1” on table. You can record this data in the box on this table just under
“X.1”. (near top left table).
4. Push “SELECT” to move down one row on table.
6. Push “SELECT” to move down one row, and then repeat steps 5 & 6 until table finished.
. See Section 5, Table 2, program item P7 on page 6 of
these instructions for how to set to L2 or L3.
5. Push “RESET” to view and record all data moving to right (back in time) in table.(except for H1.1)
History
Number
X.1
Most Recent
X.2 X.3 X.4 X.5
Least Recent
H1.1
Cumulative A-hr
H1.1
H2:Hours since
cycle ended
H2.1 H2.2 H2.3 H2.4 H2.5
H3: Length of
Cycle-hours
H3.1 H3.2 H3.3 H3.4 H3.5
H4: Amp-hour
efficiency %
H4.1 H4.2 H4.3 H4.4 H4.5
H5: Cycle Low
% Full
H5.1 H5.2 H5.3 H5.4 H5.5
H6: Cycle Min.
volts
H6.1 H6.2 H6.3 H6.4 H6.5
H7: Day’s
Maximum Volts
H7.1 H7.2 H7.3 H7.4 H7.5
H8: Day’s
Minimum Amps
H8.1 H8.2 H8.3 H8.4 H8.5
H9: Day’s percent
amp-hr charge
H9.1 H9.2 H9.3 H9.4 H9.5
Date of record______________________
To aid in system analysis, view values programmed in Program modes P1, P2 and
P3 and record them here: (See Section 5, Table 2, page 6 of these instructions.)
5 day Log Info
5 Charge-Discharge cycle info
Program mode item
Value
P1: voltage “charged” setpoint
Volts
P2: current “charged” setpoint
Amps: % of P3 value
P3: Battery capacity setting
Amp-Hr