Instruction Manual

5 switches on top row select the data to be
displayed from the items shown above switch.
Push switch repeatedly to cycle through all items
assigned to it. Two items (from two different
switches) can be displayed at once. Green lights
above switches show which switches are showing
display data.
Label for top 5 switches:
transparent
pocket
Each switch can be
assigned arbitrarily up to 5 display items. Assignment
for each switch to the desired items is accomplished
by program modes P1-P5. A card may then be
printed with these items and inserted in
of front panel. A "Word" file is available
("Pentametric Label Template") which can be
modified and printed to easily produce this label on
your printer.
When an item is showing in the display that can be "reset",
this indicator light will go on. When lighted, pushing " "
will show (in display) which (of possible 2 items) will be
reset. If the wrong item, quickly release and push again.
Holding " " down will show a timer number in the
display that will quickly go from 9 to 0. The will not
occur until the number goes to 0.
RESET
RESET
RESET
IWhen an is "active" this
light will flash. Pushing
" " will show
what alarm or alarms are active in
the display. "Audible" alarms also
start a sound tone sequence when
it alarm first starts. Pushing this
switch also silences this.
alarm
ALARM/OFF VIEW
" " switch selects one of
the four "display modes" in the list shown
here. for how switches
operate in those four modes.
Other displays
See figure 3
Sol amp. Batt. Amps. Bat%Ful. Bat volts. Days
sinceSol amp-hr
Sol W-hr charged.
Operation of switches in the "5 button" mode.
This is the usual display mode.
When in this mode, "other displays" light will be OFF.
Figure 2
9