Instruction Manual

System History mode (SH) allows
access to "Periodic Logged Data" (see
section 4.A.2 ).
Program Mode (P) allows you to observe
and change all programmable data. See
section 4.A.4.
All Data Mode (AD) allows access to all
display data available on the PentaMetric. See
section 4.A.5
Battery discharge voltage profile logged data
mode(BH)
See section 4.A.3
RESET (programon/off) button toggles from
to . When in
mode, flashing cursor will appear in display.
OBSERVE
DATA CHANGE DATA CHANGE DATA
When
, the UP/DOWN
switches allow view of
different program data.
When data,
they cause data to
change.
OBSERVING
DATA
CHANGING
When
, the
RIGHT/LEFT
switches move the
cursor right and
left.
CHANGING
DATA
RIGHT and LEFT arrow switches access
. Goes forward
or back in increments of 5% battery capacity.
data
going back or forward in time
UP and DOWN arrow switches access the
different data recorded at one sample
date/time. The "bottom" position is the
recorded date/time.
UP and DOWN arrow switches access
different all (of about 40) different displays
available in the PentaMetric.
RIGHT and LEFT
arrow switches show
data going back or
forward in time for
the same type data.
Switch functions for "OTHER DISPLAY" modes
These operate when "other display" lamp is on. Use "other displays" switch to turn lamp on (or off) and cycle through
these.
Note: blinking lamps tell you which switches are active in these modes.
Figure 3.
10