TM-2030 Installation & User Guide

ManualsBrandsBogart Engineering ManualsWind and Solar EnergyBogart Engineering BMS-TM-A-100 Battery Management System With TM-2030A, SC-2030 & 100A Shunt

History data--displays only when program P7 is set to L3 or L4.

H1: Cumulative lifetime Amp-hours drawn from the battery. Acts like an odometer for batteries. Press and hold Reset for 5 seconds to reset to 0.00

History data: for each of the last five charge-discharge cycles: P7 must be set to L3 or L4. Press and hold Select until H1.1 appears. Use SELECT but-

ton go down the table rows. For each row, push RESET to step back in time up to five earlier charge cycle periods. Historydata:retainedinmemorywhenpower

turnedoﬀ

Visitwww.bogartengineering/supportformoreinformaon.

Permissiblebaeryvoltage:8-65Volts

Designedforamaximumnominal48voltsystem(nottoexceed65volts)

MeterPowerRequirement:PowerfrommainbaeryB1:9-65V,32mA

withdisplaylighted.16mAwithdisplayoﬀ.

Baerycapacityseable

10to10,000Amp-hrs.

Dimensions:

TM-2030-RV:4-1/4highx3x1-3/8inchdepthwith1/2in.ﬂanges

TM-2030-A:4-1/2x4-3/4panelwithcircuitboard1-1/8(max)

SerialData:5VoutputstreamwithallTriMetricrealmedataASCIIcoded.

Chargecriteriadeﬁnedby:Filteredvoltageabove

Voltageset-point.Filteredamps

lessthanampsset-point.TimegreaterthanTimeset,allthreeadjustable.(Filtered

meconstant:140seconds).Seewebsitefordetaileddescripon.

Technical Information

Important:Allchargingsourcesandloadsmustconnecttothe“load”sideoftheshunt.Amps

displaywillnotreﬂectampscorrectlyifG2andSIGarenotwiredproperlyand/orcurrentsources

aren’tconnected.Addionally,P1andP3mustbeprogrammedandcriteriamustbemetonce

before

%Fullwillshowavalue.Pleasereviewthisinformaonbeforecontacngus.