Product Manual

Quick User Guide
Refer to full Instruction before use
Method ‘one’ can be used on the wheels of all vehicles that have adequate clearance
between the wheel and the brake, steering and any other mechanical parts of the
vehicle. If there is any doubt, use method ‘two’ or consult a mechanic.
Method one Connect through rim
Method two Form a snare
Read safety tips first
Lay BOG OUT along ground and attach ‘short
tails’ end to selected wheel by passing one red
connector tie through rim and tying firmly using
sheet bend knots. Be certain wheel can rotate
freely without BOG OUT catching on steering
or brake parts. Align BOG OUT in line with
wheel and towards the direction you want the
vehicle to move (front wheel for forward and
rear wheel for reverse). Attach other end of
BOG OUT to a suitable anchor point
Read safety tips first
Lay BOG OUT along ground and attach ‘long
tails’ end around selected wheel by passing
BOG OUT over the tyre and returning the long
tails along the ground back to the device. Tie
each of the tails to the BOG OUT to form a
snare using two red connector ties. Align BOG
OUT in line with wheel and towards the
direction you want the vehicle to move (front
wheel for forward and rear wheel for reverse).
Attach other end of BOG OUT to a suitable
anchor point