Installation Guide

Allen

Wrench

Press Down

Tension

Adjustment

Fig. 6

Release

Fig. 7

Additional Information

a.) Gate can be adjusted to swing up to 180º.

b.) Hinges have self-closing feature, which can be

disabled if desired (see hinge tension adjustment).

NOTE:

HINGE TENSION IS PRE-SET AT THE FACTORY

AND USUALLY D

OES NOT REQUIRE

ADJUSTMENT.

If you wish to change tension

setting/gate swing speed, or completely disable

the self-closing feature, please see the following:

Hinge Tension Adjustment

a.) Place included Allen wrench into head of tension

adjustment pin in hinge. The head is at the end

closest to the "+" or "-" symbol on the hinge

barrel (Fig. 6).

b.) Following the indicators on the "+" or "-"

symbol on the hinge barrel, press down on

the tension adjustment pin and turn a quarter turn

toward the "+" to tighten, or toward the "-" to

loosen until satis ed (Fig. 6).

i.) Self-closing feature can be disabled by using

the Allen wrench to push down and turn

towards the "-" symbol until the gate no

longer shuts on its own.

ii.) Do not over-loosen the tension adjustment

pin, as this may damage the tension spring.

c.) When you have set the desired tension, simply

release the downward pressure on the tension

adjustment pin to lock it back into the hinge barrel.

Tabs on pin head will  t into notches in hinge barrel

when pin is in fully locked position (Fig. 7).