Instructions / Assembly

ManualsBrandsBOERBOEL ManualsGate Hardware73024464

Allen

Wrench

Press Down

Tension

Adjustment

Fig. 5

Release

Fig. 6

Additional Information

- Gate can be adjusted to swing up to 180º.

- When mounting gate on left gate post, head

of tension adjustment pin and + or - symbol on

hinge should be facing up.

- When mounting gate on right gate post, head

of tension adjustment pin and + or - symbol on

hinge should be facing down.

- Hinges have self-closing feature, which can

be disabled if desired (see hinge tension

adjustment).

NOTE:

HINGE TENSION IS PRE-SET AT THE FACTORY

AND USUALLY D

OES NOT REQUIRE

ADJUSTMENT. If you wish to change tension

setting/gate swing speed, or completely disable

the self-closing feature, please see the following:

Hinge Tension Adjustment

a.) Remove cover from hinge. Place included Allen

wrench into head of tension adjustment pin in

hinge. The head is at the end closest to the + or -

symbol on the hinge barrel (Fig. 5).

NOTE:

DO NOT remove the Allen wrench or release the

tension on the tension adjustment pin at any

time during the adjustment.

b.) Following the indicators on the + or - symbol

on the hinge barrel, press down on the tension

adjustment pin and turn toward the + to tighten,

or toward the - to loosen (Fig. 5).

- Self-closing feature can be disabled by using

the Allen wrench to push down and turn

towards the “-” symbol until the gate no

longer shuts on its own.

- Do not over-tighten or over-loosen the

tension adjustment pin, as this may

damage the tension spring.

c.) When you have set the desired tension, simply

release the downward pressure on the tension

adjustment pin to lock it back into the hinge barrel.

Tabs on pin head will  t into notches in hinge barrel

when pin is in fully locked position (Fig. 6).