Installation Guide

3
1
2
Install Latch:
NOTE:
As delivered, the heavy-duty self-latching gate
latch is con gured to be mounted to the left of the
gate (as viewed from inside the gate). If you prefer
to mount the latch to the right of the gate, you
will need to re-con gure it per “To Recon gure for
Right-Side Mounting”.
a.) Hold latch against the side of the post and mark
locations of pilot holes, as shown (Fig. 1).
b.) Drill four 3/32" pilot holes into the post.
c.) Place four 1" screws through the screw holes on the
larger, side-surface of the post plate (Fig. 2).
d.) Place the four spacers onto the screws (on the
opposite side of the post plate), so they will be
between the post plate and the post when post
plate is mounted (Fig. 2).
e.) Secure latch to side of post with four 1" phillips
screws (Fig. 3).
Install Striker Bar:
a.) Close the gate and insert striker bar into latch,
while holding it  rmly against the gate.
b.) Mark pilot holes through the screw holes (Fig. 4).
c.) Remove striker bar and drill 3/32" pilot holes.
d.) Place striker bar on gate and secure with
four 1" phillips screws
NOTE:
A padlock can be placed through the holes at the
top of the latch for added security.
Post Plate
Fig. 1
Fig. 2
Fig. 3
Fig. 4