Instructions / Assembly

Snow fence is designed to CREATE drifts rather than to prevent them. Snow drifts form
wherever the wind slows down, so the basics of drift control are (1) keep a blizzard wind
moving, or (2) slow it down where you want the snowdrift. Snow fences act as
windbreaks, causing blowing snow to be deposited as drifts where it is stored.
Proper installation is critical. Snow fence should be positioned upwind of the desired
drift area, noting the prevailing wind direction. Posts should be strong as they will be the
weakest link where tensile strength is concerned (metal U-posts should not be used).
Bury posts 1/3 their height and place no more than 8 feet apart. The fence should be
pulled taught, and support wires should stabilize end posts to prevent sagging. Fence
should be attached to the upwind side of the post to minimize tearing. There should be
a 5" minimum gap at the bottom of the fence to prevent burying. The higher the fence
from the ground, the further away the drift will start.