Owner`s manual

24
S T E P
9
A. Face the Left Side and Right Side of the GDCC210 towards each other as shown in the
diagram.
NOTE: Certain hardware may need to be removed to complete this installation.
The hardware was pre-installed to aid with finalizing the assembly.
B. Connect Cross Frame (E) and Flat Plate (H) to both the Left Side Upright Frame (F) and the
Right Side Upright Frame (F) using:
Four 3 (M10x75 hex head bolt)
Eight 19 (M10 washer)
Four 13 (M10 nylon nut)
C. Remove the following pre-installed hardware in order to install Pull Up Bar (C):
Six 6 (M10x80 hex head bolt)
Eight 19 (M10 washer)
Six 13 (M10 nylon nut)
Two 37 (26.5mm steel bushing)
Two 29 (21.5mm steel bushing)
D. Install Pull Up Bar (C) onto Top Frame (B) and secure using:
Six 6 (M10x80 hex head bolt)
Eight 19 (M10 washer)
Six 13 (M10 nylon nut)
Two 37 (26.5mm steel bushing)
Two 29 (21.5mm steel bushing)
E. Now you may wrench tighten all hardware on the unit.
Be careful to assemble all components
in the sequence they are presented.
Finger tighten all hardware in this step unless otherwise noted.