Assembly Instructions

STEP

Be careful to assemble all components

in the sequence they are presented.

NOTE:

Finger tighten all hardware first in this step. Wrench tighten ALL hardware at the

end of STEP 2B. Some components may be pre-assembled. Nylon lock nuts will not

fully screw onto bolts, they must be wrench tighten to fully go on.

2A. Attach Top Frame (D) to Chrome Upright (B) using:

2 - (#2) M12X70mm Hex Head Bolt

4 - (#7) M12 Flat Washer

2 - (#9) M12 Nylon Lock Nut

2B. Attach Top Frame (D) to Top Frame of the Power Rack (L) using:

2 - (#3) M10X80mm Hex Head Bolt

4 - (#8) M10 Flat Washer

2 - (#10) M10 Nylon Lock Nut

1 - (#24) Steel Plate

2C. Route Top Cable (#20) and install four Pulleys (#15) as shown in

Step 2 Drawing using:

4 - (#5) M10X50mm Hex Head Bolt

8 - (#8) M10 Flat Washer

4 - (#10) M10 Nylon Lock Nut

2 - (E) Steel Plate

2D. Attach Chain (4pcs) Link (#18) to the eyelet end of Top Cable (#20)

2E. Attach Chain (4pcs) Link (#18) to Sliding Frame (C).

2F. Route Low Cable (#19) and install three Pulleys (#15) as shown in

Step 2 Drawing using:

1 - (#5) M10X50mm Hex Head Bolt

2 - (#4) M10X65mm Hex Head Bolt

6 - (#8) M10 Flat Washer

3 - (#10) M10 Nylon Lock Nut

2 - (E) Steel Plate

2G. Attach Chain Link (#18) to the eyelet end of Low Cable (#19)

2H. Attach Chain Link (#18) to Base Frame (A).