Technical data

IBIS
6
CONNECTION TO POWER SUPPLY
– After filling the kettle, posi-
tion it on the base unit (
➐
).
Ensure that the kettle body
is seated correctly on the con-
tact unit on the base unit (
➐
).
– Connect the mains plug to
the power supply and press
down the ON/OFF switch (
➎
).
Note: Ensure that the
ON/OFF switch is able to
move freely.
SWITCHING OFF
– Your kettle has an automatic ON/OFF switch and will switch
itself off automatically as soon as the water boils.
– You can switch off the kettle at any time by press up the
ON/OFF switch (
➎
). If the kettle body is lifted from the
base unit, it will switch off automatically.
Note: The kettle cannot be switched off by hand if the
switch is not free to move, or if the ON/OFF switch
is pressed down.
POURING OUT WATER
– To remove the kettle from the base unit (
➐
), hold it by its
handle. Ensure that the kettle body remains level while
lifting it from the base unit (
➐
).
– Pour the water from the spout with the lid (
➊
) closed.
Note: Please take care when pouring out water as
boiling water can cause scalds.
SWITCHING THE KETTLE ON AGAIN
– If the kettle was switched off by hand, it can be switched
on again at any time.
– You may switch the kettle on again as soon as the built-in
thermal safety cut-off switch has had sufficient time to cool.
➐➑
/