Application Guide

COLOR
TOUCHSCREEN
39
Output hopper full.
Remove the cards from the output hopper
on the lamination module.
Messages relating to cards
Messages relating to the laminator
Card jammed in the
lamination module.
Print jobs are
interrupted.
The laminator
door is open.
Close the door.
The laminator
is ready.
The lamination module heats up for a few seconds.
It is reactivated when the required temperature is reached.
The lamination temperature is either too high or too low.
Turn off the laminator and then turn it on again.
If the problem persists, call support.
For other warning messages concerning the cards, refer to the chapter “Warnings and
Diagnostics” in the printer section, “Messages relating to cards” paragraph.
!