Application Guide

COLOR
TOUCHSCREEN
35
LAMINATOR SETTINGS
When you tap the button, you come to an initial screen with four buttons and a second
screen with two buttons.
When you tap the button at the top left, you come to
this window. Here you can enable or disable parallel
mode. The “ON” position is the mode enabled by
default. A new card can begin printing as soon as
the previous card enters the lamination module.
This mode optimizes the production of cards, thanks
to the simultaneous operation of the print module
and the lamination module.
When you tap the button at the top right, you come to
the lamination settings window.
No lamination
Front side
lamination + flip
Back side
lamination + flip
Front side lamination
Back side lamination
Lamination front +
back (lamination of
the front, then the back)
Lamination back + front
(lamination of the back,
then the front)
Lamination settings
Parallel mode
Adjustment of temperature and
lamination speed
Lamination-only wizard
Return to the first screen
Alternate patch
management
Offset settings
Go to the second
screen