Operation Manual

11
ENGLISH
Troubleshooting Guide
PROBLEM POSSIBLE CAUSE SOLUTION
NoLCDDisplay Batteries not installed InstallBatteries
Batteries installed incorrectly CheckPolaritymatches
Batteries are dead Replacebatteries
LCDDisplayshown
but no function
Noskincontact UseConductiveGelonconductive
area of belt and directly onto skin
Unit not snapped on
belt correctly
Check that the unit is connected
firmlywithbothconnectors
to the belt
Intensitylevelatminimum PushON/HIbuttontoincrease
intensity.Replacebatteries
Microprocessor hang up ResetbypressingRESETbuttonor
removingbatteriesfor1minute.
Re-insertbatteries
Batteriesarelow Change batteries
LCD Display function
normal, but nothing occurs
Intensitysettoolow PushON/HIbuttonseveral
times to increase
NotenoughConductiveGel
on the belt
PutmoreConductiveGel
betweenbeltandskin
Usedgelisnotwaterbased Readlabelofthegelused.
Makesureyoufind‘water’or
The belt is positioned
incorrectly
Movebeltaroundtolocateyour
trigger points
Beltiswornorhasoil
deposits
Clean the belt or replace by
contacting the supplier
Batteriesarelow Change batteries
Microprocessor hang up Change batteries
LCD Display not functioning
correctly, all buttons do not
work
Batteriesarelow ResetbypressingRESETbuttonor
removingbatteryfor
1minute.Re-insertbattery
Change batteries