Specifications

11VEDEX 3300
For the Installer
Docking to the accumulator
Abbreviations
EXP
AV
LV
SÄV
AV
AV T
AV T
TG
AV
BV
MV
CP2
SV1
SV2
T
T
T
VVB
ACCU ACCU
T
ACCU
ELK
RC
AV
AV T AV T AV T
AV
AV
CP1
AV
EXP
AV
LV
SÄV
AV
TG
AV
BV
MV
CP2
SV1
SV2
T
T
T
VVB
ACCUACCU
ELK
RC
AV
AV TAVT
AV
CP1
AV
Docking to several tanks with thermal or electronic charge control and open expansion tank
When the boiler’s temperature exceeds the set charge
temperature (for example, 75°C) the charge pump starts,
which then transfers heat from the boiler to the accumula-
tor. The electronic charge control ensures that the water
temperature to the bottom of the boiler does not drop so
much that there is a risk of condensation.
Charger pack 2 is recommended for this connection.
Docking to thermal outlet with several tanks and open expansion tank
Note! Reconnection is required in the electrical panel for this type of docking. See ”Electrical installation” – ”Reconnection”.
When the boiler’s temperature and flue gas temperature
exceeds the set temperature on the relevant thermostat,
the charge pump starts, which then transfers heat from
the boiler to the accumulator tanks. Once all the wood
has been burned and the flue gas temperature drops, the
charge pump stops automatically.
The return line that is connected to the special thermal
outlet distributes the return temperature in the boiler in
such a way as to eliminate the risk of condensation.
Charger pack 1 is recommended for this connection.
BV
AV
SÄV
VVB *
EXP
BV A V AV
CP1
CP2
SV1
SV2
T
T
T
VVB
ACCU ACCU
ELK
AV T AV T
EXP
AV
LV
SÄV
CP2
SV1
SV2
T
T
T
VVB
ACCU ACCU
T
ACCU
ELK
AV
AV T AV T AV T
AV
AV
CP1
BV
AV A V
AV Shut-off valve
BV Check valve
CP1 Charge pump
CP2 Circulation pump
ELK Electrical cassette/immersion heater
EXP Expansion tank
LV Venting valve
MV Motor valve
RC Control box
SV1 Shunt valve
SV2 Mixer valve
SÄV Safety valve
TG Temperature sensor
VVB Hot water heater
Docking to the accumulator