Installation Guide

Page 4 of 4 EN
Installation continued:
1. Connect the pullout hose into the quick connection.
2. Install the retraction weight to the pullout hose above
the loop on the pullout side. Install the retraction weight
by unscrewing the screws while holding the barrel of the
weight closed. Open the weight and enclose the pullout
hose into the tted opening inside the weight. Finish by
securely closing the weight and replacing the screws to
hold it closed, enclosing the pullout hose within.
3. Attach the water supply lines to the hot and cold service
stops and turn on the water. The hot supply line can be
identied by red markings on the supply line, and the
cold supply line by blue markings; some hoses may
have both red and blue markings and are suitable for
use with either line.
4. Remove the spray head by gently pulling it down and
twisting clockwise to unscrew it from its connection.
Hold the hose and be sure to aim the water stream into
the bottom of the drain to reduce splashing. Run the
water for 1-2 minutes at a mixed temperature to remove
any dirt or debris that may be in the line and could
damage the spray head.
5. Reattach the spray head and check for leaks.
Pullout Hose Quick Connection
Retraction Weight Installation Retraction Weight Placement
ON
OFF
User Control Guide:
Turn Water ON/OFF
HOT
COLD
Water Temperature Regulation
www.bocchiusa.com
[e-mail]
877-565-2221
678-878-3771