Installation Guide

ManualsBrandsBOCCHI ManualsDrain PartsTraditional 10 in. x 2.5 in. Stainless Steel Oval Kitchen Faucet Deck Plate

Page 3 of 4 EN

Installation:

1. Double check to be certain that the water is shut off at

the service stops before you begin.

2. If necessary, remove the old faucet.

3. Clean the mounting area and surface, and dry thoroughly.

4. Insert the new faucet in the mounting hole.

NOTE: If you are using an optional deck plate, install

it now. Simply set the deck plate into place over the

faucet mounting hole and drop the faucet through

the deck plate hole as you also drop it through the

countertop hole. Once the faucet is securely installed in

place, it will hold the deck plate in place.

5. If using the stabilizer ange, install it now. Stabilizer

anges should be used with thin or exible countertops,

and with stainless steel sinks. The stabilizer should be

installed with the at triangular side facing up, and the

tube side facing down, then be slid onto the faucet shaft

from underneath the countertop to help stabilize the

faucet from below.

6. Slide the mounting hardware onto the shaft of the

faucet from the underside keeping the water supply

lines inside the mounting ring. The order of mounting

hardware should be, starting with the rst one, closest to

the underside of the countertop: (1st) rubber seal, (2nd)

stainless steel washer, (3rd) mounting ring.

7. Tighten the mounting ring and all parts and insert

the 3 screws provided with the faucet into the 3

corresponding holes on the mounting ring. Tighten

using the Phillips head screwdriver.

CAUTION: Do NOT overvtighten or use a power drill to

tighten the screws.

Tools and Materials:

Adjustable

Wrench

Phillips Head

Screwdriver

Faucet Insertion

Mounting Installation

NOTE: Special tools may be needed to install faucet mounting holes, or

water lines; if not already done, please consult a professional to perform any

additional steps to prep the space for the installation of these faucets.

RUBBER SEAL

STAINLESS

STEEL WASHER

MOUNTING RING

MAX 2-3/8 In.

RUBBER SEAL

STAINLESS

STEEL WASHER

MOUNTING RING

MAX 1-3/4 In.

Mounting With Flange

Mounting Without Flange

Installation view: