Installation Guide

Page 2 of 4 EN
Hardware:
Included with all BOCCHI Faucets:
• Mounting Hardware: rubber seal (1pc.), stainless steel
washer (1 pc.), mounting ring (1 pc.), screws (3 pcs.)
• Retraction Weight (1 pc.)
• Pullout Hose (1 pc.)
• 2 Supply Hoses (1 pc. hot and 1 pc. cold)
• Optional Stabilizer (1 pc.) to be used if the faucet is
installed on a thin and exible countertop or with a
stainless steel sink.
Technical Information:
Water Pressure
Recommended 20 - 75 psi
Maximum 145 psi
Hot Water Temperature
Recommended 120°F - 140°F (48.9°C - 60°C)
Maximum 160°F (15.6°C)
Flow Rate
Maximum 1.75 GPM
Size Intallation
Required hole size in
countertop/sink
1-3/8 In.
Maximum thickness of
countertop/sink
2-3/4 In.
Before you begin:
Included with all BOCCHI Faucets:
• BOCCHI recommends that this faucet be installed by a
licensed professional plumber/installer.
• Please read over the entire installation instructions
before beginning the installation.
• Images in these instructions are generic and may vary
slightly from your exact model.
• Make sure you have all the needed tools and parts to
complete the installation. Ensure that the area has been
properly prepped for the preferred installation setting.
• Keep this installation guide and your receipt for proof of
purchase and for future reference.
• Care and Cleaning Guides and Warranty information
for these faucets may be found at www.bocchiusa.com
• All information in these instructions is based on the
latest product information available at the time of
publication. BOCCHI reserves the right to make revisions
in the design of products without notice, as specied in
the Price Book.
Faucet insertion with plate
IMPORTANT: It is imperative that you follow all local plumbing codes and
standards to assure correct installation and hot water temperature at the
water heater.
IMPORTANT: Shut off water at the service stops before you begin.
• Pull-down sprayheads are equipped with 2 check
valves for backow prevention.
• The supply hoses for the faucets are for use with
3/8 In. service stops. If your service stops are of a
different size, purchase adapters at your local home
center or plumbing store.
CAUTION: Do NOT bend or twist the supply
hoses! A gentle curve of no less than 2-3/4
In. diameter is allowable for space, however
tight bends, kinks, and twisting may result
in damage to the hoses.
2.75 In.
(70MM)
Optional Hardware:
Sold separately. Compatible with all BOCCHI Faucets:
• Optional Deck Plate may be used with any BOCCHI
Faucet to provide a decorative base to the faucet. All
BOCCHI Deck Plates (2180 0003 XX or 2180 0004 XX) t
all BOCCHI Faucets but are sold separately. Designed
to t across a standard 8-inch faucet drilling to hide
unnecessary holes, or other unsightly marks. All BOCCHI
Deck Plates come with a single center-drilled hole.