User guide

FORMS DESCRIPTION LANGUAGE
XEROX DOCUPRINT 180 LPS FORMS CREATION GUIDE 3-37
GRAPHIC command
Using graphics A form may consist solely of graphics (images). Up to 16 images per
page are permitted. Interpress and graphics capability (Advanced
Imaging Subsystem—AIS), enable the printing of more than 16
images per page as well as vector graphics. Refer to your
DocuPrint
180 LPS Operations Reference
for additional information on AIS.
Each graphic to be associated with a form must be specified in the
FSL file by a statement with the following syntax:
GRAPHIC name AT vpos [unit] ,hpos [unit] [SCALE [IS] n[/
d]];
Sample FSL Similar to the LOGO command, the GRAPHIC command is also
typically placed near the end of the FSL, as shown in figure 3-19.
Example:
GRAPHIC AFJ AT 10, 12;
Figure 3-20. Placing a graphic
name Name of graphic (IMG) file, found on the system disks.
vpos Specifies the vertical position of the top edge of the
graphic relative to the virtual page origin. This
parameter is a decimal number with up to two
fractional digits (except for dots, which must be an
integer). If no unit is specified, grid unit dimensions are
used as the default.
unit Unit of linear measurement, expressed as inches (IN),
centimeters (CM), or DOTS. If units are not specified,
grid unit dimensions are used.
hpos Specifies the horizontal position of the left edge of the
graphic relative to the virtual page origin. The form of
the specification is the same as for vpos.
n/d Specifies the reference scale factor. Each parameter,
n and d, must be an integer in the range of 1 to 8,
thereby allowing a reference scale factor in the range
of 1/8 to 8. The reference scale factor is multiplied by
that specified at the time the graphic was digitized,
and the product is rounded to the nearest integer in
the range 1 to 8. That integer becomes the effective
scale factor with which the graphic is imaged.
TEXT USING FONT 1 AT 83.5,2.5 ’FORM SM105’;
GRAPHIC UNICRN AT 31.5,42;
USING SOLID 2;
AT 32.2,32.2 DRAW BOX 45.6 WIDE BY 20.6 HIGH
USING SOLID 2;
AT 31.9,31.9 DRAW BOX 46.2 WIDE BY 21.2 HIGH
USING SOLID 2;
AT 31.6,31.6 DRAW BOX 46.8 WIDE BY 21.8 HIGH