User guide

FORMS DESCRIPTION LANGUAGE
XEROX DOCUPRINT 180 LPS FORMS CREATION GUIDE 3-17
If a horizontal line is to be drawn, the c
o
displacement is measured
on the y axis. If a vertical line is to be drawn, the c
o
displacement is
measured on the x axis. For example, if c
o
is 6, a horizontal line is
drawn under the sixth character row.
n Number of lines to be drawn (Default is 1)
unit Unit of linear measurement, expressed as inches (IN), centimeters
(CM), DOTS, or XDOTS. If a linear unit is specified following IN, the
co parameter is assumed to be in the same units unless specified
after c
o
. If units are not specified, the measurement is in grid units.
c
s
Coordinate of the start of the line, measured on the x or y axis,
depending on the direction of the line.
c
e
Coordinate of the end of the line, measured on the x or y axis,
depending on the direction of the line.
c
a
Absolute x or y coordinate at which to start repetitive lines in a
horizontal or vertical direction. Multiple ca parameters can be
specified. Whether ca is measured on the y or x axis depends on the
horizontal or vertical direction of the line.
c
i
An incremental number representing the grid units or linear units
between repeated lines.
Example:
AT 3 DRAW LINE FROM 4 TO 10;